not showing on my PE Basic.

I converted them to pes5.6. They are larger than 4x4. What version does your machine use?

I just read further and see you use 1.7, that must be the problem.

I downloaded them again and also the new one of the whale that you just put up. This time in SEW. I converted them using Wilcom TrueSizer. This time I can see them all. The 2 whales show they are too big for my 4X4 hoop. At least I can use one of them. Thank you Joyce

Hi, normally when this happen to me it´s because the design it´s bigger then my machine capability. Angelina

Try a larger frame. They might be too big for the frame you chose.

1 comment

by joyce500 26 May 2010

If they were too big, they would show and have a symbol of a hoop showing they were too big. These do not show at all.

They may be in a version higher than your PE Basic is capable of reading. If it is ok with Lee I will convert them for you....but you must ask Lee (Smithandsmith) first.

4 comments

by smithandsmith 25 May 2010

this is Lee and yes it is fine with me :) I hope you get to use them. Is there anything i can do to help?

by smithandsmith 25 May 2010

i use a 4x4 frame and my format is SEW but sewmom was kind enough to do the PES. Im not sure if that helps you or not

by joyce500 26 May 2010

I am using version 1.7. It is worth a try. These are the only designs that I have noticed this happening on.

by danababes 26 May 2010

Your PED Basic is up-to-date then. Just thought I'd let you know :)
Dana
xXx