by mooie24 12 Apr 2011

Brother PR600 - has anyone used a wing needle on this machine - may I ask your thoughts please

Thank you
Big hugs from London - Maria x

20276

by fannyfurkin 13 Apr 2011

ttt

19430
by mooie24 13 Apr 2011

HI cuties..
I have used a wing needle on my Innovis 700 before So I know that it works fine there..
just since getting my PR600
I packed both my innoivs away as I was begining to over take over the room lol..
Thank you for your help
Big hugs from London
Maria xx

2 comments
fannyfurkin by fannyfurkin 13 Apr 2011

I have not used a wing needle in my pr620, in fact I have never used a wing needle at all, but if it was me I would just go for it and try it out, that is how I do things. If I broke the needle plate then I would buy a new one. but it is more likely you will break the needle so then you will know if it works or not.

mooie24 by mooie24 13 Apr 2011

we think a like I normally just go for it..this is the first time I have been a little nervous lol
Big hugs from London
Maria xx

20276
by cherylgauteng 13 Apr 2011

I would email the manufacturer and ask them - here is a link. There is a support section to use for this kind of question. I am sure that they would be very happy to answer this for you.

27028
by mops Moderator 13 Apr 2011

Maria, have you had a good look at the hole in your needle plate? I have a 4-needle (Melco EP4) and that has a small hole, like most commercial embroidery machines too. It would not accommodate a wing needle or a twin needle, like household embroidery/sewing machines such as my Designer. Stand-alone embroidery machines like the Brother 190D can't take anything wider than an ordinary sewing needle either. So I seriously doubt your PR600 will.

1 comment
mooie24 by mooie24 13 Apr 2011

Hi Mops.. it was my thought.. the hole on the foot and plate is to small.. it does fit through but tightly which made me nervous..
I will have to get my Innovis 700 out.. lol
Thank you
big hugs from London - Maria xx

145302
by kttyhwk4 12 Apr 2011

ttt

1 comment
kttyhwk4 by kttyhwk4 12 Apr 2011

BTW...do you know how to set this needle in your machine, so that you don't end up breaking the needle or messing up your bobbin case?

20661