Need a little help cuties!
Need to know if we can use thicker threads in the embroidery machine (I have the janome mc350e)?Like the pic I have attached. ...it says on the label weight 80gm....I tried it in my sewing machine and it worked!
7806
80 grs is the weight per kilometre and it corresponds with 12,5wt, usually meant for upholstery fabrics. A topstitch needle and a light weight embroidery design are needed. You can find designs for woolen thread (like Burmilana) and for 15wt thread (the Glamour threads by Madeira for instance) that would work well. Or you could enlarge a design 10-20% (without adjusting the density) to get a less dense design.
1 comment
145302I have used them but slow down your machine as they are thicker then normal thread ,use them on big designs not little stitches like a fsl angel ok hugs Carolyn
1 comment
360641To get a feel of when you can use these threads you'll have to test them with various designs. I don't think you could do fsl and have a good outcome. But your redwork idea should work. When you do your tests, if you see that it's not working out well, just stop stitching! Nothing says you have to finish a design in a test stitchout.
1 comment
by tfk
13 Feb 2015
Hahaha :)...very true....I have done several test runs like that! ;) its better to stop than to damage the machine! Thank you for the suggestions!
33641Looks like you have your answer...but don't forget to change your needle to a larger size...depending upon the thickness...you may need to go to a 14 or 16 or perhaps even an 18 needle...use either an embroidery needle or a topstitch needle...both have a larger needle eye...
2 comments
by cfidl
13 Feb 2015
Yes! I was just thinking this for myself and a little struggle I have going on.
by tfk
13 Feb 2015
Thats a good point you mentioned dragonflyer...changing needle to a bigger size! Would do that when I try....thank you! :)
318433There are designs that have been digitized for thicker threads. But it the fibers that comes off these threads if they are cotton that will bill up in your machine, so clean the bobbin case.
1 comment
33350You have your answer then!
It is always worth a try. I often use a thicker thread on some kinds of design. They are great for cross stitch for instance. However, I would not use them for filled designs. The finished product would resemble cardboard!
1 comment
by tfk
13 Feb 2015
Yeah true.....I too was thinking of trying it for designs like red work or any light ones!
Will let you all know ...if I gather the courage to experiment! ;)
140717