I have a Ruby, not the Diamond, but used it once at my dealer's. You just have to remove the hoop and turn it 180 degrees, replace it and stitch the other half of the design. So much easier than rehooping. Make sure it does not bump into something, including yourself when clipping jumps. - it 's a large hoop and needs a lot of free space around the machine. I have had the occasional mishap when using the 200x360 hoop and you don't want that to happen when stitching those large designs.

Do you have any software for your machines? You need to look at the design in the software to check where the split will happen as sometimes it does not split at a good place in the design. I too have only used this hoop at the dealer with a design all ready for the hoop. Good luck. Hugs. Nan W

Oh, good! You have been visited by the experts. I'm glad you found the place to post. You may want to look through the Q&A section. There is a tutorial that tells you exactly where to post anything. Can't wait to see your project!

So happpy you asked this. I have it but wasn't even sure how to go about trying it. Will be watching for your results. good luck.

I recently learned that I needed to buy the software to use this hoop on designs other than official viking ones. It's a disappointment to me that it wasn't mentioned when I purchased it. As usual with embroidery, another expense

Hi Kathy, I have the Viking Designer 1 which has as its largest hoop 360x150 and a Brother Quattro, the Brother has a large hoop too, 300x200 but I've not used it yet, never had a big design to make up. I'll look into it when I get out of hospital. Love Chris