Hi, Cracker! Whether I am using metallic or regular thread, I use a thread stand. Got mine at the dealer for around $5. It's a heavy piece of cast iron with a rod in it that has a loop on the end for guiding the thread. I put it behind my machine, and the top of the loop is above the height of the machine. The thread spool is standing up, not lying down, and the greater length gives the thread a chance to untwist & relax before going into the machine tension. Works great!! Best of luck to you, Marji

Jrob once gave the tip to thread the yarn through a packing peanut before threading it through te machine, even had a picture to go with it. That gives just enough friction to let it run smoothly through the machine. I just had my machine back from repairs as the thread built a rat's nest in the machine. In a place I could not reach it without opening up the whole of the machine - which I don't do with electronic ones. Cost me a bundle. So I'll use my stand again.

Have to say that the packing peanut does work. I also slow down my machine when using metalic thread. A stand also helps. I now use all three and don't have to sit at the machine while it's stitching. Good luck.
Mickey

I haven't tried that packing peanut YET, but I use a thread stand also for EVERY project:)

I have a 1500D and definately use a thread stand for all embroidery i get less breakage and best of all no ratsnests lol happy stitching :)

Hi Cracker and welcome to the Cute family.
I found using thread nets helped when stitching with metalic thread, check out my project (link below) to see how i made my own. Using all the suggestions here should certainly solve your problem. hugs n roses, Meganne

Hi, I use a thread stand as well. I found the netting a bit expensive. I have got 30 big spools! So, I cut my old stockings in sections and slip the cone through the stocking. Works a treat every time! Ops, ... yes... slow down the speed down. Good Luck! Mary