25533✽
hi Cuties, help please! Could some one explain to me how i can obtain the symetric of a design with my software embroidery studio 3 D?
Comments (7)
25533✽
by
claudenicolas
05 Jul 2009
+3✽
excuse me, I have clicked 2 times because it was very slow!!!
17461✽
by
michele921
06 Jul 2009
+3✽
I don't understand what you are looking for with your software program I will bump back to top
hope someone else can answer for you
hope someone else can answer for you
33451✽
by
marjialexa
06 Jul 2009
+3✽
I don't use 3D, Claude, and I'm not sure what you mean by 'symetric', some mistranslation here. Try again, maybe describe in more words what you want to do. We'll get it eventually, hee hee hee. Hugs, Marji
58029✽
25533✽
by
claudenicolas
06 Jul 2009
0✽
I wished to say : symmetrical, that is my design is turned towards the left, and I want the same turned towards the right, but not turned 180°.I hope that you can understand what I want.
2738✽
In my design software I can flip a design vertically or horizontally, maybe you have the same facility?
This 'mirrors' the design rather than rotate it. I think this is what you are looking for?
My software is Janome DigitizerPro.
This 'mirrors' the design rather than rotate it. I think this is what you are looking for?
My software is Janome DigitizerPro.
2 comments
Yes, it is "mirror"
Pleased to help - no stopping you now - happy creating. :)
7384✽
I just sent you a PM - so please check it. When you open a design in 3D software there will be a "frame" around it -- on each corner there is a square --- on the right side middle area is a circle and on the left side middle area is a triange - click on the triangle - and it will "flip or mirror" you design"!"