29237✽
I am making fsl ornaments using FabriSolvy.Seems to work fine but I wonder if there is a better choice.I think 2 layers works best.Advise on best/most economical washaway would be appreciated.
Comments (3)
111390✽
Hi I use Badge Master from OESD. It is very thick. I hoop one layer, stitch the lace out.Then cut around it without unhooping it. Replace a small piece in the hole and stick it down. Sew another one and do the same again. That way you don't use or waste a lot of it.
Suzanne
Suzanne
1 comment
Thank you. I'll try that tip also, I hate wasting that stuff!
6491✽
If you are in the USA The best price I have found is at Pointe to Pointe. $16.50 for 3 yards x 59" wide free shipping.
1 links:
[1]
WSS Vilene
www.pointetopointe.com
5 comments
I am and will check that out. Thank you very much. Do you use 1 layer or 2 when you do fsl with that?
I use Vilene as well and use 2 layers.
I hoop one layer and then I float a scrap piece under the hoop just the size of the design so I don't have as much waste.
I do that 'on the bottom' thing too, then the presser foot doesn't hook on the scrap if I'm sloppy!
Thank you crafter 2243, I've read one layer is enough but I don't have very good luck with that.
145791✽
I like the Dissolve-Away Mesh by Babylock. $24.95 for 25yards by 12 inches. Welcome to cute *
1 comment
Thank you. Do you use one layer or two normally when making fsl?