Your 4x4 hoop will work for a 100 mm design, so it seems like that would work. I love the precuts , but you better look at a metric ruler and your hoop to make sure! I've never been any good at converting! I like to buy mine at least 8 inches.

Yes it will 4X4 is the same as 100X100. more or less so it will definitely fit.<br />the conversion is 2.5cm equals 1 inch or to be more precise 25mm equals 1 inch. so 100mm equals 4 inches. I hope that helps.

Thank you both for your help. I was worried as my 4x4 hoop is a bit more oblong than square and I did not think the pre cut would fit the length. *4U

Your 4x4 hoop takes 100x100 mm designs, but if you want to hoop the stabiliser is has to be bigger than that. How much bigger depends on your hoop: my Designer 1 takes less than my Brother 190D and both take oblong pieces! So cut a piece of scrap 6" square and try it out for size. Then you're absolutely sure.

Sarah when u r in CT we, and in particular Yvonne, will tell you where to buy stabilizer relatively not expensive. Send Yvonne an email and she will tell you

Depends on what machine you have and how your hoop is configured. They would not work on my Brother PE780D or my Brother Quattro - would need at least 210 (roughly 8.5 inches) for either of those 4x4 hoops to have a nice amount all the way around.