8710✽
Floral Frame Font Question - How do I get the fringe part around the design to look like fringe? I'm sure I have to cut the thread, but not sure where. Thank you.
Comments (4)
5552✽
by
designcrazy
25 Apr 2011
+2✽
You will need to clip the bobbin thread and then it will become fringed. Good luck with it, I haven't done much of this kind of design, but it is fun to do.
1 comment
This means the back thread .the first time i tryed i cut on the edge but thats wrong ,turn it over and trim close towards the middle.I hope you can understand me??I am not good with words!!carolyn
17214✽
Here's a good instruction page...
http://www.emblibrary.com/EL/elprojects/SimpleProduct_ELP.aspx?CS_Catalog=Elprojects&CS_ProductID=PR1141
AlmaG.
http://www.emblibrary.com/EL/elprojects/SimpleProduct_ELP.aspx?CS_Catalog=Elprojects&CS_ProductID=PR1141
AlmaG.
11259✽
You can also use water soluble thread in your bobbin and then you won't have to worry about snipping wrong threads..Just wet it and poof the threads are dissolved. I use it alot on fringed designs...but make sure you mark the bobbin so you don't use it on regular stitching..lol...(I stitched and entire design using it)lol
1 comment
I thought about telling her about using the water soluble thread in the bobbin. I've been told it could be used, but I haven't tried it yet.
8710✽
Thank you for your responses. Since I don't have the water soluble thread, I will cut the bobbin thread in the middle. The Embroidery Library video was great. Thank you.