17488✽
Question for Embird users. I have a stock design, but I would like to add more to it. An example would be.. I have a car design, and I would like to bring that design into studio and add grass or gravel around it so it's not so plain. Is this possible? For some reason I can't bring my stock design into studio. Is there some way to add to a ready made design?
Thank You
Mary Ann
Comments (4)
17488✽
I got it figured out.
1 comment
so tell us - did you? I am assuming you did.
26714✽
I have no idea i would like to know the answer, what I have done is to mix designs but they are already deigitized. Good luck
145312✽
I'm glad you got it figured out.
For those who'd want to know how to do it, here's how I do it.
I open the design in Editor, right click on it and choose "Edit stitch file in Studio" and add whatever I want to be added.
For those who'd want to know how to do it, here's how I do it.
I open the design in Editor, right click on it and choose "Edit stitch file in Studio" and add whatever I want to be added.
17488✽
I was able to figure it out. I was doing it right, but my studio screen does not show my design in the center of the screen, so I thought the design wasn't there. When I moved my little slider bar around, my design was there, I just couldn't see it as it was hiding behind all the stuff on the right hand side of the screen. Once I slid the slider bar I could see my design. Is there a way to center the "0" so when I open studio, that it's always centered? I sure like Embird, but I think my hair is getting much thinner from pulling it...LOL.
Thanks
Mary Ann
Thanks
Mary Ann
2 comments
LOL I can relate - some EMBIRD expert will help soon 8-)
Don't know if you can get it set that way, would be nice. When I can't see it I select the object(s) in the object list and use Ctrl+Alt+C to center the design - even then I have to use the slider bars a bit.