4309✽
Avoid thread tangles in a PR600 http://jensoriginalsembroiderydesigns.yolasite.com/pr600-modification.php simple but clever :) xXx
1 links:
[1]
PR600 Modification
jensoriginalsembroiderydesigns.yolasite.com
Comments (8)
211079✽
by
shirlener88
03 Mar 2012
+4✽
Oh my - what an idea - how do you get the thread in each of those tubes - when you have change thread colors?
7 comments
I see she address' this - but I am not sure it would work that easy - all the time.
Shirlene if you knot the new thread to the old thread it will be very simple, it will just be a problem iiiffff the xxxxx thread breaks. Then I will have to use a long needle like the one I have with my overlock machine
On reading this is what she does
Maybe a strong INHALE!
brilliant
My Amaya has those tubes. First tie the thread and pull through. If that fails put a couple of inches of the new thread in the tube and use one squirt of compressed air and the thread shoots through the tube and out the front of my machine. So easy it is scary. I also have a long red piece of plastic with a tiny notch in it that came with my Amaya that can be used to pull the thread through. Compressed air is by far the favorite for everyone.
Marcelle
Marcelle
is scary. I also have a long red piece of plastic with a tiny notch in it that came with my Amaya that can be used to pull the thread through. Compressed air is by far the favorite for everyone.
Marcelle
Marcelle
20276✽
might have to try this :-)
I looked at her FAQ page too.. very interesting
Big hugs - Maria xx
I looked at her FAQ page too.. very interesting
Big hugs - Maria xx
115778✽
6803✽
by
bnilla9241
03 Mar 2012
+3✽
FANTASTIC!!! My PR 600 is in a smaller room and when I use my ceiling fan tangles can happen. I will go out tomorrow and purchase some!
Thank you for this tip!
Hugs, Bonnie
Thank you for this tip!
Hugs, Bonnie
6622✽
by
bettytaylor
03 Mar 2012
+2✽
Fabulous idea, now if I had a PR600 I would go out tomorrow and buy some tubing, but unfortunately I am still saving for this machine. lol. Thanks for sharing this idea. It sure is a winner. Betty
16302✽
7199✽
Interesting idea. I might try this with metalic thread on my single needle machine. xx
111390✽
Where do you get the little nipples that the tube fits onto? Suzanne
1 comment
um, she says they are already on the PR600, are they not? I dont have one, just sharing a link I found :)