318555✽
Embird Experts...something wierd is happening when I click on a design to open in Embird Basic...as of Friday, I now get an error message that says "Cannot read disk in drive F"...but it's a design that is on my hard drive and there is no "drive F"...when I click the red X to close...my design opens just fine...but what's with the error message and how do I get rid of it? I just started happening on Friday...Thanks...
Comments (5)
11357✽
by
wendymay60
04 Nov 2012
+3✽
This also happened to me a few times after a windows update. I went to the top of embird & chaanged the drive to " c" it was ok the next time I opened it. good luck
1 comment
Thanks...but my Embird shows Drive C...
48✽
I have the same problem! Any solutions?
1 comment
Manager opens the last drive you used, which may be a USB stick that is no longer attached. Just click on the drive you want to use at the right hand of the screen an inch or so from the top and select the file you want.
140717✽
11506✽
Try opening a design from Embird instead of clicking on a design. See if that corrects the problem.
318555✽
by
dragonflyer
03 Jul 2013
+1✽
Well, the solution was downloading an Embird update...I had sent a message and they must have corrected the problem in the new update...this was to XP, 32 bit version...
1 comment
Glad it was sorted for you.