7199✽
Does anybody know if a design can be digitized too tight???? As in a set of designs are pulling my bobbin thread up but any other design is fine. Ta, xx
Comments (2)
66927✽
by
graceandham
01 Jun 2013
+5✽
Sounds totally plausible to me. If you have Floriani Total Control Pro, ou can remove some stitches and make it more workable.
15036✽
Yes, it is possible. Would think that the density of the fill stitch is to high. If you can look at the design in a software program you shoukd be able to find out what the density is, or contact the digitizer about it.
Christie in Germany
Christie in Germany