Yesterday I played with puffy foam, well, I am not sold on it at all....First I spent an enormous amount of time digitizing this design for puffy foam, making sure all ends would be capped on everything I was using the foam on, then the result, for me, was less than adequate, so went back to the drawing board, so to speak, and used my raised satin stitch from my software and 'lo & behold, it turned out better and higher than using puffy foam..........it is neater looking and did not take near as long to digitize...what do you think? I took a close up, but you still can't see how high it is...I did the eyes and horns and down the nose on the inside..